Made this for a friend so thats why you see there name on the top of my finished photos. I took the name off for the STL file. If you want me to send you a file with your name, send me a tiny tip and I'll edit it in for you. Its easy to do it on your own if you want though also.
I printed this in PLA. The main body was printed at 30% infill with .2 layer height. I set it in the slicer to do the top at 60% infill with a .08 layer height. It took my printer about 35 hours to print this. The second file on here is the spinning gear. It will slide right in the spot at the top. I don't put them together in case that part of the print failed it would suck to have to reprint the whole thing. I used support in S3D and it mostly just added support on the hanging pipe on top and it added support on the metal nubs on the sides of the body. I think the sides of the body *may* print okay, but you most definitely need the support for the pipe on top.
The dock holds most phones, and it has a line at the bottom so you can run the cable through.
If you want to tip, its appreciated. If not, no worries. Print on!